ScanShell Scan2Contacts Guide de l'utilisateur télécharger pdf (Page 11)

Using Scan2Contacts Application State

APPLICATION STATE

When the application loads, its state is set to Enabled

by default.

Setting the application state



Press on the state button to toggle between the

enabled and disabled state.



If the application is enabled (green button),

pressing on the state button will disable the

application and the button will become gray.



If an error occurred while the application was

loaded, the state will be set to Disabled. You can

try to enable the application by pressing on the

state button. If this does not help, check if the

scanner is properly connected and try again.

Scan2Contact User Guide, version 2.0.1 7

1 2 ... 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

ScanShell Scan2Contacts Guide de l'utilisateur Page 11